 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| FST32253 Dual 4:1 Multiplexer/Demultiplexer Bus Switch with 25 Series Resistor in Outputs August 2001 Revised September 2001 FST32253 Dual 4:1 Multiplexer/Demultiplexer Bus Switch with 25 Series Resistor in Outputs General Description The Fairchild Switch FST32253 is a dual 4:1 high-speed CMOS TTL-compatible multiplexer/demultiplexer bus switch. The low On Resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. When OE is LOW, S0 and S1 connect the A Port to the selected B Port output. When OE is HIGH, the switch is OPEN and a high-impedance state exists between the two ports. The FST32253 has an equivalent 25 series resistor to reduce signal-reflection noise, eliminating the need for external terminating resistors. Features s 25 switch connection between two ports s Minimal propagation delay through the switch s Low lCC s Zero bounce in flow-through mode s Control inputs compatible with TTL level Ordering Code: Order Number FST32253M FST32253QSC FST32253MTC Package Number M16A MQA16 MTC16 Package Description 16-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow 16-Lead Quarter Size Outline Package (QSOP), JEDEC MO-137, 0.150" Wide 16-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 4.4mm Wide Device also available in Tape and Reel. Specify by appending suffix letter "X" to the ordering code. Logic Diagram Connection Diagram Truth Table Pin Descriptions Pin Name OE1, OE2 S0 , S1 A B1 , B2 , B3 , B4 Description Bus Switch Enables Select Inputs Bus A Bus B DS500472 S1 X X L L H H S0 X X L H L H OE1 H X L L L L OE2 X H L L L L Function Disconnect 1A Disconnect 2A A = B1 A = B2 A = B3 A = B4 (c) 2001 Fairchild Semiconductor Corporation www.fairchildsemi.com FST32253 Absolute Maximum Ratings(Note 1) Supply Voltage (VCC ) DC Switch Voltage (VS) DC Input Voltage (VIN)(Note 2) DC Input Diode Current (lIK) VIN < 0V DC Output (IOUT ) Sink Current DC VCC/GND Current (ICC/IGND) Storage Temperature Range (TSTG) -0.5V to +7.0V -0.5V to +7.0V -0.5V to +7.0V -50 mA 128 mA Recommended Operating Conditions (Note 3) Power Supply Operating (VCC) Input Voltage (VIN) Output Voltage (VOUT) Input Rise and Fall Time (tr, tf) Switch Control Input Switch I/O Free Air Operating Temperature (TA) 0 ns/V to 5 ns/V 0 ns/V to DC 4.0V to 5.5V 0V to 5.5V 0V to 5.5V +/- 100 mA -65C to +150 C -40 C to -85 C Note 1: The Absolute Maximum Ratings are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum rating. The Recommended Operating Conditions tables will define the conditions for actual device operation. Note 2: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. Note 3: Unused control inputs must be held HIGH or LOW. They may not float. DC Electrical Characteristics Symbol VIK VIH VIL II IOZ RON Parameter Clamp Diode Voltage High Level Input Voltage Low Level Input Voltage Input Leakage Current OFF-STATE Leakage Current Switch On Resistance (Note 5) VCC (V) 4.5 4.0-5.5 4.0-5.5 5.5 0 5.5 4.5 4.5 4.5 4.0 ICC ICC Quiescent Supply Current Increase in ICC per Input 5.5 5.5 20 20 20 20 26 27 28 30 2.0 0.8 1.0 10 1.0 38 40 48 48 3 2.5 TA = -40 C to +85 C Min Typ (Note 4) Max -1.2 Units V V V A A A A mA 0 VIN 5.5V VIN = 5.5V 0 A, B VCC VIN = 0V, IIN = 64 mA VIN = 0V, IIN = 30 mA VIN = 2.4V, IIN = 15 mA VIN = 2.4V, IIN = 15 mA VIN = VCC or GND, IOUT = 0 One Input at 3.4V Other Inputs at VCC or GND Note 4: Typical values are at VCC = 5.0V and T A = +25C Note 5: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the voltages on the two (A or B) pins. Conditions IIN = -18 mA www.fairchildsemi.com 2 FST32253 AC Electrical Characteristics TA = -40 C to +85 C CL = 50pF, RU = RD = 500 Symbol Parameter VCC = 4.5 - 5.5V Min tPHL, tPLH Propagation Delay Bus to Bus (Note 6) Propagation Delay, Select to Bus A tPZH, tPZL tPHZ, tPLZ Output Enable Time, Select to Bus B Output Enable Time, IOE to Bus A, B Output Disable Time., Select to Bus B Output Disable Time, IOE to Bus A, B 0.5 0.5 0.5 0.5 0.5 Max 1.25 6.7 6.8 6.0 5.7 5.7 VCC = 4.0V Min Max 1.25 7.3 7.3 6.4 6.4 6.5 ns ns VI = 7V for tPZL VI = OPEN for tPZH VI = 7V for tPLZ VI = OPEN for tPHZ ns VI = OPEN Figures 1, 2 Figures 1, 2 Figures 1, 2 Units Conditions Figure Number Note 6: This parameter is guaranteed by design but is not tested. The bus switch contributes no propagation delay other than the RC delay of the typical On Resistance of the switch and the 50pF load capacitance, when driven by an ideal voltage the source (zero output impedance). Capacitance Symbol CIN CI/O A Port B Port (Note 7) Parameter Typ 3 13 5 Max Units pF pF pF Conditions VCC = 5.0V VCC, OE = 5.0V Control Pin Input Capacitance Input/Output Capacitance Note 7: TA = +25C, f = 1 MHz, Capacitance is characterized but not tested. AC Loading and Waveforms Note: Input driven by 50 source terminated in 50 Note: C L includes load and stray capacitance Note: Input PRR = 1.0 MHz, tW = 500 ns FIGURE 1. AC Test Circuit FIGURE 2. AC Waveforms 3 www.fairchildsemi.com FST32253 Physical Dimensions inches (millimeters) unless otherwise noted 16-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow Package Number M16A 16-Lead Quarter Size Outline Package (QSOP), JEDEC MO-137, 0.150" Wide Package Number MQA16 www.fairchildsemi.com 4 FST32253 Dual 4:1 Multiplexer/Demultiplexer Bus Switch with 25 Series Resistor in Outputs Physical Dimensions inches (millimeters) unless otherwise noted (Continued) 16-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 4.4mm Wide Package Number MTC16 Technology Description The Fairchild Switch family derives from and embodies Fairchild's proven switch technology used for several years in its 74LVX3L384 (FST3384) bus switch product. Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. 5 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. www.fairchildsemi.com www.fairchildsemi.com |
Price & Availability of FST32253
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |